==========================================================

3D printer data set:

	iPhone6plus car holder

				3D data created by TEPP
	Technology & Electronics Picks Power (C)2014

==========================================================

[Introduction]

I changed my smartphone to iPhone6plus.
...so big!

How do I place my iPhone6plus in my car?


[Parts Overview]

You should build up this holder with 3 parts below:

a) iPhone6plus holder main part

b) joint part

c) joint arm to metal plate


You also need to prepare:

metal plate with some holes
(you may buy in D.I.Y. shop)
some screws

In detail, please see introduction movie.

and, of courese, you need 3D printer.

I tested 3D print with 'Da Vinci 1.0' (xyzprinting.com)


[Assembling]

In detail , please see how to build.


[notice]

This holder is for iPhone6 plus with shellcover.
It depends on the dimension of shellcover or case itself.


[License]

iPhone6plus car holder by TEPP is licensed under a Creative Commons Attribution 4.0 International License.


[Contact]

websiteFhttp://www.na.sakura.ne.jp/~tepp/
blogFhttp://d.hatena.ne.jp/TEPP/
twitter: TEPP
nicovideoF TEPP

